Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.6.1. Removal
6.2.6.2. Installation
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








6-2-6-1-snyatie.html

6.2.6.1. Removal

ATTENTION
The gap between the switch of signals of braking and a pedal of a brake is regulated automatically when the switch of signals of braking is installed in an opening on a pedal of a brake and turns for fixing. If the switch of signals of braking is not installed properly, the gap can be wrong that will lead to misoperation of signals of braking. Therefore, before installation of the switch of signals of braking always check correctness of installation and the provision of a pedal of a brake for a pedal it (is completely released).

After automatic adjustment of a gap of the switch of signals of braking repeated adjustment is impossible. Therefore, replace the switch new, when replacing the amplifier of brakes or a pedal, or when performing any works during which the pedal course will change.
Remove the rechargeable battery and the platform of the rechargeable battery.
Disconnect the brake highway (from the main cylinder).
Remove bolts and nuts of fastening of a pedal of a brake.
Take away the amplifier of brakes to a forward part of the car so that the fork of the amplifier of brakes did not adjoin to the brake pedal lever.
Remove a brake pedal.

Fig. 6.19. Order of removal of details of a pedal of a brake: 1 – socket of the switch of signals of braking; 2 – switch of signals of braking; 3 – cable of the drive of a butterfly valve; 4 – pedal of management of fuel supply; 5 – hinge axis; 6 – brake pedal; 7 – basic platform of a pedal





"previous page
6.2.6. Removal and installation of a pedal of a brake
following page"
6.2.6.2. Installation




d925ae9b