Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 










d925ae9b

6-2-2-proverka-urovnya-tormoznojj-zhidkosti-v-bachke-gidroprivoda-rabochejj-tormoznojj-sistemy.html

6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system

The tank for brake fluid is located in a motor compartment.
The tank has the transparent case therefore the level of brake fluid can be controlled outside.
Level of brake fluid has to be always closer to a tag "MOVE".
If the level of brake fluid too low, before removal of a stopper from a compensation tank pure rags wipe a stopper and the place about a stopper from pollution to exclude hit of dirt in a hydraulic contour of brakes.
Add the recommended brake fluid in a tank. Mixing of various types of brake fluid can damage hydraulic system.
It is necessary to check hoses of the brake system, at least, two times a year.
For the prevention of sudden failure of the brake system carefully check a condition of all pipelines and connections, paying special attention to the following:
Metal pipelines should not have scratches and the centers of corrosion and have to be far from sharp edges which can damage them.
The brake hose has to be elastic, not have anguishes and cracks and is closed strongly up in tips. The carving of tips of a hose should not have damages. If when pressing a brake pedal the hose is inflated, means threads of cords are torn. At detection of any of these defects the hose needs to be replaced. On hoses the mineral oils and lubricants dissolving rubber should not get.
All brackets of fastening of pipelines have to be whole and are well fixed. Weakening of fastening or destruction of brackets leads to vibration of pipelines which causes their breakages.
Leak of brake fluid from connections of the main cylinder with pipelines and a tank is not allowed.
At detection of malfunctions replace the damaged details new. Irrespective of their state, replace flexible hoses new after 120 thousand km of a run or after five years of operation of the car to warn sudden gaps because of rubber aging. The brake hose rubbing against a suspension bracket detail wears out and finally fails.
For check use a mirror and illumination.

"previous page
6.2.1. Check and adjustment of elements of the brake system
following page"
6.2.3. Removal of air from the brake system