220.127.116.11. Measurement of a radial gap of a neck of a cam-shaft
Remove a valve pusher.
|Fig. 2.155. Installation of the calibrated plastic wire
Place pieces of the calibrated plastic wire from above on cam-shaft necks, having arranged them along an axis (fig. 2.155)
Establish a cover of bearings of a cam-shaft. (see. "Instructions on assembly of a cam-shaft").
Uncover cam-shaft bearings. (see. "Instructions on dismantling of a cover of the bearing of a cam-shaft").
Measure a radial gap.
If the gap does not meet standard, replace a head of the block of cylinders.
Normal gap of 0,04-0,08 mm.
Maximum gap: 0,09 mm.