Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of the air conditioning system
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air duct
8.5.9. Removal and installation of the compressor of the air conditioning system
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and installation of the condenser
8.5.14. Check of the condenser
8.5.15. Removal and installation of lines of coolant (LF)
8.6. Tables
 










d925ae9b

8-5-9-snyatie-i-ustanovka-kompressora-sistemy-kondicionirovaniya-vozdukha.html

8.5.9. Removal and installation of the compressor of the air conditioning system

Disconnect a negative wire from the rechargeable battery.
Discharge coolant.
Remove the right mudguard and an antisplash guard.
Weaken a tension of a driving belt and take off a belt.

ATTENTION
At hit of moisture or impurity in a cooling contour the cooling ability of a contour decreases and abnormal noise is heard. Always close traffic jams an open fitting after removal of any elements of a contour of cooling for prevention of hit of moisture or impurity in a contour.


Fig. 8.68. Removal of the compressor of the conditioner: 1 – cooler hose (top); 2 – a hose of a cooler No. 4 (cars with the left arrangement of steering); 3 – socket of the magnetic coupling; 4 – compressor of the air conditioning system

Remove in the order specified in the figure 8.68.
Establish as it should be, the return to removal.
Adjust a tension of a driving belt.
Execute operational tests of air conditioning system.
"previous page
8.5.8. Removal and installation of a back air duct		 following page"
8.5.10. Dismantling and assembly of the obgonny coupling