Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Hinged components of a body
8.3. Body glazing
8.4. Seats
8.5. Conditioner and heater
8.5.1. Coolant
8.5.2. Air filter
8.5.3. Block of the air conditioning system
8.5.4. Evaporator
8.5.5. Broad valve
8.5.6. Condenser
8.5.7. Check of a radiator of a heater
8.5.8. Removal and installation of a back air duct
8.5.9. Removal and installation of the compressor of the air conditioning system
8.5.10. Dismantling and assembly of the obgonny coupling
8.5.11. Adjustment of the obgonny coupling
8.5.12. Check of the obgonny coupling
8.5.13. Removal and installation of the condenser
8.5.14. Check of the condenser
8.5.15. Removal and installation of lines of coolant (LF)
8.6. Tables
 










d925ae9b

8-5-4-isparitel.html

8.5.4. Evaporator

The evaporator of new type in which the multiline evaporator (consisting of an element of condensation and an element of overcooling) and a gas-liquid separator (modulator) are integrated is used.
The case of the evaporator is covered with polymer which contains antibacterial substance for elimination of a source of an unpleasant smell and distribution of bacteria.
Placement of tanks in the top and lower part of the block of the evaporator, and also an internal design of plates allowed to provide the following:
– efficiency of heat exchange is improved;
– distribution of temperatures became more uniform;
– the evaporator became thinner.

Fig. 8.64. Operation of the evaporator


In the accepted cycle of preliminary cooling after coolant passes through an element of condensation of the evaporator, liquid and gaseous coolants which could not be liquefied are cooled in an overcooling element again. Thus, coolant is sent to the evaporator in almost completely liquefied state.


"previous page
8.5.3. Block of the air conditioning system
following page"
8.5.5. Broad valve