Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.11. Dismantling and assembly of the main cylinder
6.2.11.1. Dismantling
6.2.11.2. Assembly
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








6-2-11-2-sborka.html

6.2.11.2. Assembly

Install secondary and primary pistons.
Install a new sealing ring on the lock screw.
Completely drown primary piston assembled.
Establish and tighten the lock screw.
Inhaling moment: 2,0–2,4 N · m.

Fig. 6.36. First check of knot of the secondary piston


Press and release knot of the secondary piston, make sure that it is kept by the lock screw (fig. 6.36).
Install the secondary piston so that the opening was turned to a lock pin and primary piston.
Establish a new sealing ring on a lock pin.
Completely drown primary piston assembled.
Establish and tighten a lock pin.
Inhaling moment: 6,9–9,8 N · m.

Fig. 6.37. Second check of knot of the secondary piston


Press and release knot of the secondary piston, make sure that it is kept by the lock screw (fig. 6.37).

"previous page
6.2.11.1. Dismantling
following page"
6.2.12. Removal and installation of a forward brake disk