Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from the brake system
6.2.4. Check of the backpressure valve of a vacuum hose (amplifier of brakes)
6.2.5. Removal and installation of a vacuum hose (amplifier of brakes)
6.2.6. Removal and installation of a pedal of a brake
6.2.7. Removal and installation of the main brake cylinder
6.2.8. Check of the sensor of level of liquid
6.2.9. Removal and installation of the vacuum amplifier of brakes
6.2.10. Check of the vacuum amplifier of brakes
6.2.10.1. Check of operation of the vacuum amplifier
6.2.10.2. Tightness check
6.2.10.3. Check and adjustment of length of the speaker of a rod
6.2.11. Dismantling and assembly of the main cylinder
6.2.12. Removal and installation of a forward brake disk
6.2.13. Replacement of front brake shoes
6.2.14. Removal and installation of the back disk brake mechanism
6.2.15. Check of the parking brake system
6.2.16. Removal, check and installation of the back sensor of speed of a wheel of ABS
6.2.17. Removal and installation of the hydraulic block of anti-blocking system of brakes
6.3. Tables
7. Onboard electric equipment
8. Body
 








6-2-10-3-proverka-i-regulirovka-dliny-vystupayushhego-shtoka.html

6.2.10.3. Check and adjustment of length of the speaker of a rod

By means of the manual vacuum pump create in the amplifier of a brake vacuum – 66,7 kPa (–500 mm of mercury.).

Fig. 6.31. Adjustment of length of a press rod


Weaken a lock-nut and adjust length of a press rod so that length "In" became equal to a preset value (fig. 6.31).
Regulate, so far the gap between the acting part of a rod and the screw will not become equal 0 mm – nominal length at indications of the vacuum gage of 66,7 kPa (-500 mm of mercury.).

"previous page
6.2.10.2. Tightness check
following page"
6.2.11. Dismantling and assembly of the main cylinder