Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. General information
5.2. General checks
5.3. Working operations with the steering mechanism
5.3.1. Precautionary measures during the work with system of passive safety (SRS)
5.3.2. Removal, check and installation of a steering wheel and steering column
5.3.3. Dismantling of the steering mechanism and steering drafts
5.3.3.1. Dismantling of steering draft
5.3.3.2. Dismantling of a shaft of a gear wheel and case
5.3.3.3. Dismantling of the top bearing and epiploon
5.3.3.4. Dismantling of an epiploon of an internal guide
5.3.4. Check of the steering mechanism and steering drafts
5.3.5. Removal and installation of the pump of the hydraulic booster
5.4. Tables
6. Brake system
7. Onboard electric equipment
8. Body
 








5-3-3-3-razborka-verkhnego-podshipnika-i-salnika.html

5.3.3.3. Dismantling of the top bearing and epiploon

Fig. 5.23. Removal of an epiploon and top bearing


Install special adaptation, as shown in the figure 5.23.
Using a press, remove an epiploon and the top bearing, without putting pressure to edge of the case of the valve.

Fig. 5.24. Removal of the case of the holder


Cut off the deformed area a drill (fig. 5.24).

ATTENTION
Accurately take out the holder, trying not to damage U-shaped laying.

Sort the holder.

"previous page
5.3.3.2. Dismantling of a shaft of a gear wheel and case
following page"
5.3.3.4. Dismantling of an epiploon of an internal guide




d925ae9b