3.2.7.3. Adjustment of a preliminary tightness in the bearing

Establish holders of bearings of primary and secondary shaft in a case of the main transfer (laying is removed).

Install a coupling case on a transmission eye in the block with the main transfer, establish a differential bearing holder in a coupling case. Place a pipe piece on a holder of the bearing and press it against the stop in a coupling case.

Fig. 3.55. Installation of a holder of bearings in special devices

Install holders of bearings in special devices (selector), as shown in the drawing of fig. 3.55.

NOTE Turn the selector before elimination of the gap designated by an arrow in the figure 3.55