Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.2.1. General information
3.2.2. Check and replacement of oil in the mechanical transmission
3.2.3. Removal and installation of the sensor of a speedometer of the car (without anti-blocking system of brakes)
3.2.4. Replacement of an epiploon (differential)
3.2.5. Removal and installation of the mechanism of gear shifting
3.2.5.1. Instructions on installation of a cable of the choice of transfer
3.2.6. Coupling case, dismantling of elements of a case of the main transfer
3.2.7. Check and assembly of components of differential and case of the main transfer
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

3-2-5-snyatie-i-ustanovka-mekhanizma-pereklyucheniya-peredach.html

3.2.5. Removal and installation of the mechanism of gear shifting




Remove the rechargeable battery, its tray and an arm of fastening of a tray.
Fig. 3.29. Mechanism of gear shifting of the Mazda 3 car: 1 – gear shifting lever; 2 – cover panel; 3 – clip; 4 – washer; 5 – sealing plate; 6 – main cable of the drive of switching; 7 – main cable of the choice of transfer; 8 – gear shifting lever block

Remove an element of the air filter.

Fig. 3.30. Removal of the dashboard

Having turned off seven bolts, two screws of fastening and having taken out three percussion caps, remove the dashboard (fig. 3.30).
Fig. 3.31. Removal of the module of management of system of improvement of stability: 1 – bolts; 2 – sockets of power supply and management; 3 – module

Turn off three bolts of fastening and remove the module of management of system of improvement of stability (fig. 3.31).
Fig. 3.32. Removal of the control unit of climatic installation: 1 – conditioner; 2 – control unit; 3 – sockets of power supply and management

Remove the control unit of climatic installation (fig. 3.32).
Fig. 3.33. Removal of the lower air ducts: 1 – right air duct; 2 – left air duct

Remove the lower air ducts (fig. 3.33).
Remove the lever and a cover of the lever of gear shifting.
Remove gear shifting drive cables.
Remove the gear shifting lever block.
You make installation as it should be, the return to removal.
Establish an element of the air filter.
After installation, be convinced that the lever of gear shifting can smoothly move to any situation.
"previous page
3.2.4. Replacement of an epiploon (differential)		 following page"
3.2.5.1. Instructions on installation of a cable of the choice of transfer