Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.2.1. General information
3.2.2. Check and replacement of oil in the mechanical transmission
3.2.3. Removal and installation of the sensor of a speedometer of the car (without anti-blocking system of brakes)
3.2.4. Replacement of an epiploon (differential)
3.2.5. Removal and installation of the mechanism of gear shifting
3.2.6. Coupling case, dismantling of elements of a case of the main transfer
3.2.7. Check and assembly of components of differential and case of the main transfer
3.2.7.1. Installation of bearings of a gear gear wheel
3.2.7.2. Assembly of a cylindrical pin
3.2.7.3. Adjustment of a preliminary tightness in the bearing
3.2.7.4. Installation of differential in a coupling case
3.2.7.5. Installation of a case of the main transfer
3.2.7.6. Elimination of gaps of primary, secondary shaft and shaft of differential of a case of the main transfer
3.2.7.7. Measurement of loading of primary, secondary shaft and shaft of differential of a case of the main transfer
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








d925ae9b




3-2-7-2-sborka-cilindricheskogo-shtifta.html

3.2.7.2. Assembly of a cylindrical pin

Fig. 3.53. Installation of a new cylindrical pin


Establish a new cylindrical pin, as shown in the figure 3.53 to hold an axis of satellites.
Measure a gap according to the following procedure.
Establish the left and right power shafts in differential.
Support power shafts by prisms.

Fig. 3.54. Measurement of a gap of satellites


Measure a gap of both satellites (fig. 3.54).
Gap: 0,050–0,150 mm.
If results of measurements differ from norm, replace the worn-out and damaged details.

"previous page
3.2.7.1. Installation of bearings of a gear gear wheel
following page"
3.2.7.3. Adjustment of a preliminary tightness in the bearing