Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents of CO/CH in the fulfilled gases
2.2.3. Measurement of a compression in engine cylinders
2.2.4. Check of a belt of the drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Removal of sealant
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of gas distribution (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of gas distribution (L3)
2.2.10. Gas distribution mechanism drive chain
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the spool-type valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.18.1. Installation of a maslootrazhatelny cap
2.2.18.2. Installation of a head of the block of cylinders
2.2.18.3. Installation of cam-shafts
2.2.19. Assembly of the drive of the mechanism of gas distribution
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-2-18-1-ustanovka-maslootrazhatelnogo-kolpachka.html

2.2.18.1. Installation of a maslootrazhatelny cap

Napressuyte a maslootrazhatelny kopachok on the directing valve plug manually.

Fig. 2.184. Installation of a maslootrazhatelny cap


Slightly to a dopressuyta special adaptation, using the kapron hammer (fig. 2.184).
Install valves, springs of valves and the top plates of springs of valves.

Fig. 2.185. Installation of crackers of valves


Establish valve crackers, using special devices (fig. 2.185).
Establish lifting eyes of the engine.
Establish new laying of a head of the block of cylinders.

"previous page
2.2.18. Assembly of a head of the block of cylinders
following page"
2.2.18.2. Installation of a head of the block of cylinders




d925ae9b