3.4.8.3. Installation

Fig. 3.143. Installation on a connecting shaft of a new clip

Establish on a connecting shaft a new clip by a cut up. Make sure that diameter of a clip does not exceed norm (fig. 3.143).

After installation, measure outer diameter.

If it differs from norm, repeat installation with use of a new clip.

Maximum outer diameter: 31,2 mm.

Insert a power shaft into a wheel nave.

Fig. 3.144. Installation of a power shaft

Apply gearbox oil on a working edge of an epiploon (fig. 3.144).

Insert a power shaft into the transmission.

After installation pull the case of the internal hinge on yourself to be convinced of reliability of fixing of a power shaft.

You make installation of other components as it should be, the return to removal.