3.4.8.2. Removal

Merge transmission oil.

Remove a support of the brake mechanism.

Remove a brake disk.

Remove the spherical hinge of a steering rod end of draft.

Remove a rack of the stabilizer of cross stability.

Turn off bolts of fastening and remove the sharovy hinge of the forward lower lever (a back part).

Remove the sharovy hinge of the forward lower lever (a forward part).

Fig. 3.140. Installation of a spare nut on a power shaft

Establish a spare nut on a power shaft so that the nut was aflush from the end of a power shaft (fig. 3.140).

Strike a nut with the copper hammer to weaken landing of a power shaft in a wheel nave.

Separate a power shaft from a wheel nave.

ATTENTION Sharp edges of a power shaft can cut or punch an epiploon. Be careful at separation of a power shaft from the transmission.

Fig. 3.141. Removal of the left power shaft from the transmission by means of a core

Separate the left power shaft from the transmission, using as the lever the core inserted between the hinge and the transmission, as shown in the figure 3.141.

Fig. 3.142. Installation of special device for keeping of semi-axial gear wheels

Install the special device for keeping of semi-axial gear wheels after removal of a connecting shaft in the transmission.