Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.2.1. Check of a gap in the hug bearing of a forward wheel
3.4.2.2. Check of a gap in the hug bearing of a forward wheel
3.4.3. Removal and installation of a nave of a forward wheel
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a nave of a back wheel
3.4.6. Removal and installation of a forward connecting shaft
3.4.7. Assembly and dismantling of a connecting shaft
3.4.8. Removal and installation of a power shaft (cars with the mechanical transmission)
3.4.9. Removal and installation of a power shaft (cars with the automatic transmission)
3.4.10. Removal and installation of a power shaft (cars with the mechanical transmission)
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








3-4-2-1-proverka-zazora-v-podshipnike-stupicy-perednego-kolesa.html

3.4.2.1. Check of a gap in the hug bearing of a forward wheel

Remove a forward wheel.
Disconnect a forward left support of a disk brake.
Remove a forward disk.

Fig. 3.100. Check of a gap in the hug bearing of a forward wheel


Install the indicator of hour type against a nave of a wheel (fig. 3.100).
Moving a wheel nave manually in the axial direction, measure a gap in the hug bearing.
At most: 0,05 mm.
If the gap exceeds a maximum, replace the bearing.

"previous page
3.4.2. Forward power shafts
following page"
3.4.2.2. Check of a gap in the hug bearing of a forward wheel