Mazda 3 since 2003
	1. Operation and maintenance of the car
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
			2.6.1. Check of a belt of the drive of auxiliary units
			2.6.2. Check of thermal gaps in the mechanism of the drive of valves
			2.6.3. Check of a compression
			2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
			2.6.5. Replacement of laying of the block of cylinders
			2.6.6. Replacement of a forward epiploon of a bent shaft
			2.6.7. Replacement of a back epiploon of a bent shaft
			2.6.8. Removal and installation of the engine
				2.6.8.1. Removal
				2.6.8.2. Removal of the socket of the main block of safety locks
				2.6.8.3. Removal of support of the engine No. 3 and No. 4
				2.6.8.4. Removal of a support of the engine and No. 4
				2.6.8.5. Installation of a support of the engine and No. 4
				2.6.8.6. Installation of a support of the engine No. 3
		2.7. Lubrication system
		2.8. Cooling system
		2.9. System of an admission
		2.10. Fuel system
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. System of ignition
		2.13. Control system
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-6-8-6-ustanovka-opory-dvigatelya-n3.html

2.6.8.6. Installation of a support of the engine No. 3

Tighten hairpins of fastening of a support of the engine No. 3.

Inhaling moment: 7–13 N · m.

Establish a support of the engine No. 3 and temporarily tighten bolts and nuts of fastening.

Tighten engine No. 3 support bolts.

Remove a motor jack and the extra.

Fig. 2.286. Installation of special device for measurement of pressure of oil

Tighten bolts of fastening of a support of the engine No. 1 (fig. 2.286).

Inhaling moment: 93,1–116,6 N · m.