Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.6.8.1. Removal
2.6.8.2. Removal of the socket of the main block of safety locks
2.6.8.3. Removal of support of the engine No. 3 and No. 4
2.6.8.4. Removal of a support of the engine and No. 4
2.6.8.5. Installation of a support of the engine and No. 4
2.6.8.6. Installation of a support of the engine No. 3
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








d925ae9b




2-6-8-2-snyatie-razema-glavnogo-bloka-predokhranitelejj.html

2.6.8.2. Removal of the socket of the main block of safety locks

Fig. 2.282. Release of fastening of the socket of the main block of safety locks


Release a uvula as shown in the figure 2.282.
Lift the zaporyany lever and remove the socket.

"previous page
2.6.8.1. Removal
following page"
2.6.8.3. Removal of support of the engine No. 3 and No. 4