Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents of CO/CH in the fulfilled gases
2.2.3. Measurement of a compression in engine cylinders
2.2.4. Check of a belt of the drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Removal of sealant
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of gas distribution (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of gas distribution (L3)
2.2.10. Gas distribution mechanism drive chain
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the spool-type valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.17.1. Installation of a drive plate (model with the automatic transmission), a flywheel (model with the mechanical transmission)
2.2.17.2. Installation of the oil pallet
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of the drive of the mechanism of gas distribution
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

2-2-17-1-ustanovka-vedushhego-diska-modeli-s-avtomaticheskojj-korobkojj-peredach.html

2.2.17.1. Installation of a drive plate (model with the automatic transmission), a flywheel (model with the mechanical transmission)

Hold a bent shaft from a provorachivaniye by means of special adaptation.
Fig. 2.180. Order of tightening of bolts of fastening of a flywheel or drive plate

Tighten fastening bolts in the order specified in the figure 2.180 for several receptions.
Install other components as it should be, the return to removal and dismantling of the block of cylinders.
"previous page
2.2.17. Assembly of the block of cylinders (termination)		 following page"
2.2.17.2. Installation of the oil pallet