Mazda 3 since 2003
1. Operation and maintenance of the car
1.1. Description of the car
1.1.1. Dimensions and general view of the car
1.1.2. Technical characteristics
1.1.3. Identification data of the car
1.1.4. Podkapotny space
1.1.5. Filling capacities of units and systems. The recommended operational materials
1.1.6. Keys, locks of doors, hatch, anticreeping system
1.1.7. Governing bodies and combination of devices
1.1.8. Information display
1.1.9. Electronic immobilizer (anticreeping system)
1.1.9.1. Security alarm system (additional equipment)
1.1.9.2. Conditions of operation of the sound alarm system (autonomous siren)
1.1.9.3. Turning on of the alarm system in the protection mode
1.1.9.4. Shutdown of the sensor of penetration into the car
1.1.9.5. Removal of the alarm system from the protection mode
1.1.9.6. Switching off of an alarm signal
1.1.9.7. Marking of existence on the car of the security alarm system
1.1.10. Heater, conditioner and system of ventilation of interior of the car
1.1.11. Lever of the drive of the parking brake system
1.1.12. Seats
1.2. System of passive safety
1.3. Use of the car to destination
1.4. Elimination of the malfunctions which arose in way or before a start of motion
1.5. Tables
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

1-1-9-4-otklyuchenie-datchika-proniknoveniya-v-avtomobil.html

1.1.9.4. Shutdown of the sensor of penetration into the car

In the listed below cases it is necessary, having turned on the security alarm system, to switch-off the penetration sensor (it will exclude unjustified operations of the security alarm system):
– in the car there was a mobile object;
– in the car there was a subject which can be rolled on salon at a car list (for example when the car is installed on the deck of the ferry);
– near the car metal objects, for example the portal of the automatic jet washer move.
To switch-off the penetration sensor, press the button of shutdown of the sensor located on the remote control, not later 20 with after the locking button was pressed.
At the same time lamps of indexes of turn will blink three times.
Again to turn on the penetration sensor, remove the alarm system from the mode of protection on duty and then turn on the alarm system. The sensor of penetration is activated at each turning on of the security alarm system in the mode on duty. In order that the sensor of penetration did not work, at each turning on of the alarm system in the mode of protection press the button shutdowns of the sensor on the remote control.

"previous page
1.1.9.3. Turning on of the alarm system in the protection mode
following page"
1.1.9.5. Removal of the alarm system from the protection mode