Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. System of power supply
7.3. System of lighting
7.3.1. The forward combined lamp
7.3.1.1. Main characteristics
7.3.1.2. Gas-discharge headlight
7.3.1.3. Design and work of a gas-discharge headlight
7.3.1.4. Function of detection of malfunctions
7.3.1.5. System of automatic alignment of headlights
7.3.1.6. Work at change of loading of the car
7.3.1.7. Work at the movement of the car
7.3.1.8. A control system of lighting at the movement of the car
7.3.2. The back combined lamp and the internal combined lamp
7.3.3. Removal and installation of the forward combined headlight
7.3.4. Adjustment of light of headlights
7.3.5. Removal and installation of a lamp of a headlight
7.3.6. Removal and installation of a gas-discharge lamp of a headlight
7.3.7. Removal and installation of a lamp of a parking lamp
7.3.8. Removal and installation of the forward index of turn
7.3.9. Removal and installation of the side index of turn
7.3.10. Adjustment of light of a forward fog light
7.3.11. Removal and installation of the back combined lamp
7.3.12. Removal and installation of the internal combined lamp
7.3.13. Removal and installation of a lamp of illumination of registration plate
7.3.14. Removal and installation of an additional signal of braking on a back spoiler
7.3.15. Removal and installation of a forward lamp of illumination of salon
7.3.16. Removal and installation of the trailer switch of a door
7.3.17. Removal and installation of the lighting lamp of an ashtray
7.3.18. Removal and installation of a lamp of illumination of the lock of ignition
7.3.19. Removal and installation of a lamp of illumination of a ware box
7.3.20. Removal and installation of operating lighting switch on the dashboard
7.4. Screen wipers and windscreen washers
7.5. Immobilizer
7.6. Checks of electric equipment
7.7. Tables
8. Body
 










d925ae9b

7-3-1-7-rabota-pri-dvizhenii-avtomobilya.html

7.3.1.7. Work at the movement of the car

1. At the movement with the included headlights the control unit of automatic alignment (main) receives on an entrance a car speed signal from the block of the ABS/TCS HU/CM or DSC HU/CM system and the signal based on fluctuations of a suspension bracket from forward and back sensors of automatic alignment.
2. On the basis of a car speed signal the control unit of automatic alignment calculates the angle of acceleration and checks change of speed of the car. Besides, if there is a difference between two signals of forward and back sensors of automatic alignment, the control unit of automatic alignment (main) checks actual position of the car. The same block calculates the size of adjustment of an optical axis on the basis of these two signals and gives a signal on the control unit of automatic alignment (additional).
3. The control unit of automatic alignment compares the actual and standard position of a reflector, and then brings a signal of management to the executive mechanism of alignment of a headlight.

NOTE
When the ignition key is transferred to position of ON, within several seconds it is possible to hear a sound of operation of the executive mechanism of alignment of headlights, it is normal as there is a check of the operational mode of system.

At movement along the bad or uneven road function of automatic alignment would cause effect of blinking, leading to dazzle of drivers of oncoming cars. For prevention of it automatic alignments of headlights happens to delay.

"previous page
7.3.1.6. Work at change of loading of the car
following page"
7.3.1.8. A control system of lighting at the movement of the car