Check of a gap in the hug bearing of a back wheel. Mazda 3 (since 2003 release)
Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.4. Removal and installation of a nave of a back wheel
3.4.4.1. Check of a gap in the hug bearing of a back wheel
3.4.5. Removal and installation of a nave of a back wheel
3.4.6. Removal and installation of a forward connecting shaft
3.4.7. Assembly and dismantling of a connecting shaft
3.4.8. Removal and installation of a power shaft (cars with the mechanical transmission)
3.4.9. Removal and installation of a power shaft (cars with the automatic transmission)
3.4.10. Removal and installation of a power shaft (cars with the mechanical transmission)
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








3-4-4-1-proverka-zazora-v-podshipnike-stupicy-zadnego-kolesa.html

3.4.4.1. Check of a gap in the hug bearing of a back wheel

Remove a back wheel.
Disconnect a forward support of a disk brake.

Fig. 3.117. Removal of a brake disk


Remove a brake disk (fig. 3.117).

Fig. 3.118. Check of a gap in the hug bearing of a back wheel


Install the indicator of hour type against a nave of a wheel (fig. 3.118).
Moving a wheel nave manually in the axial direction, measure a gap in the hug bearing.
At most: 0,05 mm.
If the gap exceeds a maximum replace the bearing.

ATTENTION
Performance of the following procedures without preliminary removal of the sensor of speed of a wheel of anti-blocking system of brakes can lead to break of a chain in a plait of wires if the plait is by mistake tense. Before performance of the following operations remove the sensor of speed of a wheel of anti-blocking system of brakes (from a body) and fix it in the suitable place where the sensor will not be by mistake damaged when performing service.

"previous page
3.4.4. Removal and installation of a nave of a back wheel
following page"
3.4.5. Removal and installation of a nave of a back wheel




d925ae9b