Removal. Mazda 3 (since 2003 release)
Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.3.1. Removal
3.4.3.2. Installation
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a nave of a back wheel
3.4.6. Removal and installation of a forward connecting shaft
3.4.7. Assembly and dismantling of a connecting shaft
3.4.8. Removal and installation of a power shaft (cars with the mechanical transmission)
3.4.9. Removal and installation of a power shaft (cars with the automatic transmission)
3.4.10. Removal and installation of a power shaft (cars with the mechanical transmission)
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








3-4-3-1-snyatie.html

3.4.3.1. Removal

Fig. 3.103. Knocking-out of a fillet of a lock-nut of a nave of a wheel


Beat out the bent part of a lock-nut outside a small chisel and the hammer (fig. 3.103).
Block a nave having pressed a brake.
Turn off a lock-nut.

Fig. 3.104. Removal of a nave of a wheel from a drive shaft


Place a nave assembled in a vice. Remove a wheel nave from a drive shaft, using special devices (fig. 3.104).
If the internal ring of the bearing remained on a wheel nave axis, cut through an internal ring of the bearing to residual thickness, (about 0,5 mm).

Fig. 3.105. Removal of an internal ring of the bearing


After that remove a ring a chisel (fig. 3.105).

Fig. 3.106. Removal of the hug bearing


Remove the wheel bearing, using special devices (rice 3.106).

Fig. 3.107. Marking of a casing of a nave and rotary fist


Mark the protection cover and a rotary fist for further installation (fig. 3.107).

Fig. 3.108. Removal of the protection cover of a nave


By means of a chisel remove the protection cover (fig. 3.108).

Fig. 3.109. Removal of bolts of a nave


Establish a nave in a press and remove bolts (fig. 3.109).

NOTE
Bolts of a nave should be removed only in case of their replacement.

"previous page
3.4.3. Removal and installation of a nave of a forward wheel
following page"
3.4.3.2. Installation




d925ae9b