Installation. Mazda 3 (since 2003 release)
Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.9.1. Removal and installation of system of an admission
2.9.1.1. Removal
2.9.1.2. Installation
2.9.2. Removal and installation of the regulator of idling
2.9.3. Removal and installation of a pedal of management of fuel supply
2.9.4. Check and adjustment of a cable of the drive of a butterfly valve
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-9-1-2-ustanovka.html

2.9.1.2. Installation

Fig. 2.311. An order of installation of fastenings of recirculation of the fulfilled gases


Establish bolts and a nut of fastening of a pipe of recirculation of the fulfilled gases in the order shown in the figure 2.311.

Fig. 2.312. Combination of adjusting tags throttle branch pipe and air hose


Combine tags on a throttle branch pipe and an air hose (fig. 2.312).

NOTE
Before installation of an air duct of system of an admission, be convinced that rubber fastenings on an arm of the rechargeable battery are on the places.
At installation of an air duct of system of an admission in rubber fastenings use soap water.

Make sure that two rubber fastenings are established on an arm of the rechargeable battery.
Establish an air duct of system of an admission in rubber fastenings.

Fig. 2.313. Installation of the panel of a radiator and air duct of system of an admission


Using a bracket, fix the panel of a frame of a radiator and an air duct of system of an admission as shown in the figure 2.313.

Fig. 2.314. Installation of the socket of the RSM block


Completely insert the PCM block socket into the air filter and press the lever before click (fig. 2.314).
Install other components as it should be, the return to removal.

"previous page
2.9.1.1. Removal
following page"
2.9.2. Removal and installation of the regulator of idling




d925ae9b