Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.4.1. Removal
2.6.4.2. Removal of a natyazhitel of a chain
2.6.4.3. Removal of a chain of the drive of the mechanism of gas distribution
2.6.4.4. Installation of a chain of the drive of the mechanism of gas distribution
2.6.4.5. Installation of a chain of the drive of the mechanism of gas distribution
2.6.4.6. Installation of a support of the engine No. 3
2.6.4.7. Installation of a support of a bolt of fastening of a pulley of a bent shaft
2.6.4.8. Installation of a cover of a head of the block of cylinders
2.6.4.9. Final installation
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

2-6-4-6-ustanovka-opory-dvigatelya-n3.html

2.6.4.6. Installation of a support of the engine No. 3

Fig. 2.266. Tightening of hairpins of fastening of a support of the engine No. 3


Tighten hairpins of fastening of a support of the engine No. 3 (fig. 2.266).
Inhaling moment: 7–13 N · m.
Establish a support of the engine No. 3 and temporarily tighten bolts and nuts of fastening.

Fig. 2.267. Order of tightening of bolts of fastening of a support of the engine


Tighten fastening bolts in the order shown in the figure 2.267.
Inhaling moment:
1 (nuts) – 44–61 N · m;
2 (bolts) – 74.5–104.9 N · m.

"previous page
2.6.4.5. Installation of a chain of the drive of the mechanism of gas distribution
following page"
2.6.4.7. Installation of a support of a bolt of fastening of a pulley of a bent shaft