Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.4.1. Removal
2.6.4.2. Removal of a natyazhitel of a chain
2.6.4.3. Removal of a chain of the drive of the mechanism of gas distribution
2.6.4.4. Installation of a chain of the drive of the mechanism of gas distribution
2.6.4.5. Installation of a chain of the drive of the mechanism of gas distribution
2.6.4.6. Installation of a support of the engine No. 3
2.6.4.7. Installation of a support of a bolt of fastening of a pulley of a bent shaft
2.6.4.8. Installation of a cover of a head of the block of cylinders
2.6.4.9. Final installation
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-6-4-4-ustanovka-cepi-privoda-mekhanizma-gazoraspredeleniya.html

2.6.4.4. Installation of a chain of the drive of the mechanism of gas distribution

Fig. 2.260. Alignment adjusting a shponochny flute of an asterisk of the crankshaft on an adjusting tag


Level a shponochny flute of an asterisk of the crankshaft on an adjusting tag, then install the piston of the first cylinder in the provision of VMT (fig. 2.260).
Level adjusting tags on asterisks of camshafts so that they formed a straight line at alignment on top a horizontal surface of a head of the block of cylinders.
Establish a gas distribution mechanism drive chain.

Fig. 2.261. Removal of the limiter


After installation of the regulator of a chain take out a wire or the paper clip established in a natyazhitel of a chain and pull a gas distribution mechanism drive chain. Remove the installed limiter, at installation of a new natyazhitel of a chain (fig. 2.261).
Make sure that the chain of the drive of the mechanism of gas distribution has no sagging, and then again check correctness of installation of asterisks.
Turn a bent shaft clockwise on two turns, and then check the moment of opening and closing of valves.

"previous page
2.6.4.3. Removal of a chain of the drive of the mechanism of gas distribution
following page"
2.6.4.5. Installation of a chain of the drive of the mechanism of gas distribution




d925ae9b