Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.3.1. Lubrication system
2.3.1.1. Check of pressure of oil
2.3.1.2. Replacement of engine oil
2.3.1.3. Replacement of an oil filter
2.3.1.4. Removal and installation of the oil cooler
2.3.1.5. Removal and installation of the oil pallet
2.3.1.6. Removal and installation of the oil pump
2.3.2. Cooling system
2.3.3. Fuel system
2.3.4. System of release
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

2-3-1-5-snyatie-i-ustanovka-maslyanogo-poddona.html

2.3.1.5. Removal and installation of the oil pallet

Stop the engine and wait, so far the engine and engine oil will not cool down.
Disconnect a negative wire of the rechargeable battery.
Remove the lower protective cover.
Merge engine oil.
Remove a forward cover of the engine.

Fig. 2.205. Removal of the oil pallet: 1 – masloizmeritelny probe; 2 – oil pallet


Pick up the phone of the masloizmeritelny probe and the oil pallet (fig. 2.205).

Fig. 2.206. Alignment of the oil pallet on the block of cylinders


Use a corner to level the oil pallet on the block of cylinders from a forward cover of the engine (fig. 2.206).

Fig. 2.207. Putting sealant before installation of the oil pallet


Apply kremniyevoorganichesky sealant on the interfaced surface of the oil pallet, as shown in the figure 2.207.

Fig. 2.208. Order of tightening of bolts of fastening of the oil pallet


Tighten bolts of fastening of the pallet in the order specified in the figure 2.208.
Check oil level.
Start the engine and check lack of leak of oil. In the presence of leak define a defective part, repair or replace it.

"previous page
2.3.1.4. Removal and installation of the oil cooler
following page"
2.3.1.6. Removal and installation of the oil pump