Mazda 3 since 2003
1. Operation and maintenance of the car
1.1. Description of the car
1.1.1. Dimensions and general view of the car
1.1.2. Technical characteristics
1.1.3. Identification data of the car
1.1.4. Podkapotny space
1.1.5. Filling capacities of units and systems. The recommended operational materials
1.1.6. Keys, locks of doors, hatch, anticreeping system Folding key Remote control of the central lock автомобиляз Wearable card "Advanced Key" Maintenance of the wearable card "Advanced Key" Area of coverage of the wearable card "Advanced Key" Locking unlocking of doors, trunk lid and back lifting door Launch of the engine The remote control which is built in the wearable card "Advanced Key" Maintenance of the remote control Replacement of a battery of the remote control Locking and unlocking of locks key Locking and unlocking of doors by means of the internal button of blocking Central electric lock, prevention of locking of locks Blocking of locks of back doors from opening from interior of the car A back door of the luggage compartment (cars with a body "hatchback") Locking and unlocking of a door of the luggage compartment by means of a key Opening of a back door of the luggage compartment Closing of a back door of the luggage compartment Luggage compartment A trunk lid (cars with a body "sedan") Opening of a trunk lid pressing the cylinder of a larva of the lock Plafond of lighting of the luggage compartment Locking and unlocking of locks by means of buttons in external handles Function of automatic locking of locks Opening and closing of a cowl The hatch on a roof Raising of the rear edge of a cover of the hatch Longitudinal movement of a cover of the hatch A sun-protection shutter of the hatch on a roof Hatch and cover of a filling mouth of the fuel tank
1.1.7. Governing bodies and combination of devices
1.1.8. Information display
1.1.9. Electronic immobilizer (anticreeping system)
1.1.10. Heater, conditioner and system of ventilation of interior of the car
1.1.11. Lever of the drive of the parking brake system
1.1.12. Seats
1.2. System of passive safety
1.3. Use of the car to destination
1.4. Elimination of the malfunctions which arose in way or before a start of motion
1.5. Tables
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body


1-1-6-4-tekhnicheskoe-obsluzhivanie-nosimojj-karty-advanced-key.html Maintenance of the wearable card "Advanced Key"

Check that the battery was correctly focused by the electric poles concerning the card case. At the wrong installation of a battery it is possible to flow electrolyte. When replacing a battery be careful not to bend electric contacts, and also preserve electric contacts against pollution by oil. You watch that dirt did not get to the case of the remote control. It can put the panel out of action. If replacement is made incorrectly, there is a danger of explosion of a battery. When replacing use only batteries of the same type (CR2025 or completely equivalent elements). At utilization of the served batteries follow the following rules:
– isolate positive and negative poles of a battery by means of cellophane or an insulating tape;
– do not sort batteries;
– do not throw batteries into fire or into water;
– do not deform and do not break batteries.

Point the following signs to the discharged condition of a battery:
– at the idle engine the signaling device of "KEY" (green color) located on the dashboard blinks;
– the system does not work, when pressing buttons of management the indicator which is built in the card does not light up;
– reduction of range of operation of the wearable card.

In order to avoid failure of the wearable card "Advanced Key" replace a battery only at the service station of the official dealer of Mazda. At independent replacement of a battery make the following actions:
1. Take out an auxiliary key from the card;

Fig. 1.16. Replacement of a battery of the wearable card "Advanced Key"

2. By means of the flat screw-driver release a battery cover, then turn and remove its (fig. 1.16);

Do not turn a cover on too big corner, it can lead to its damage.

3. Insert a tip of the flat screw-driver into a cut and take out a battery;
4. Insert a new battery (the CR2025 type or completely to it equivalent), so that the positive pole of an element (+) settled down on the same party, as marking (+), put on a cover;
5. Turn and close a cover.
In case of loss or plunder of the wearable card immediately address on the service station of the official dealer of Mazda for replacement and blocking of operation of the lost or stolen card. At the same time it is necessary to capture with itself all wearable cards "Advanced Key" which remained with you.

"previous page Wearable card "Advanced Key"
following page" Area of coverage of the wearable card "Advanced Key"