Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. General information
7.2. System of power supply
7.3. System of lighting
7.4. Screen wipers and windscreen washers
7.5. Immobilizer
7.5.1. Inclusion / blocking of function of reprogramming of a key without use of special adaptation (WDS or an analog)
7.5.2. Removal and installation of the lock of ignition
7.5.3. Procedure of reprogramming of an immobilizator
7.5.3.1. Anticreeping system
7.5.3.2. Installation of a code
7.5.3.3. Cancellation of a code
7.5.3.4. Switching off of the mode of anticreeping blocking
7.6. Checks of electric equipment
7.7. Tables
8. Body
 








7-5-3-4-vyklyuchenie-rezhima-protivougonnojj-blokirovki.html

7.5.3.4. Switching off of the mode of anticreeping blocking

Enter the operating code to deactivate anticreeping system and to resume normal operation of the audioblock.
1. Install the ignition switch in position of ACC. (On the display there will be a blinking indication of "CODE".)
2. At first press the AUTO-M button, then at the same time press the button of channel 6 approximately on 2 with until on the display indication of "CODE" appears.

NOTE
The procedure 3 has to be performed during 10 from later procedure 2.

Fig. 7.80. Scheme of the mode of anticreeping blocking 1


3. Buttons of the choice of channel 1-4 are used for input of the chosen code. The button 1 sets the first figure of a code, 2 – the second, 3 – a third, 4 – the last figure. You enter number during 10 pages. If indication on the display disappears, repeat procedures starting with the first.


Fig. 7.81. Scheme of the mode of anticreeping blocking 2


ATTENTION
Three consecutive mistakes, including installation of the switch of ignition in position of LOCK and shutdown the audioblka, makes active anticreeping system then it will be impossible to restore normal operation of the audioblock.

4. During display of a code, press the AUTO-M button, then at the same time press the button of channel 6 approximately during 2 pages. Indication of "CODE" will be displayed on the display about 5 pages.

Fig. 7.82. Scheme of the mode of anticreeping blocking 3


5. If on the display there is an indication of "Err" (mistake), repeat the procedure since operation 1.


"previous page
7.5.3.3. Cancellation of a code
following page"
7.6. Checks of electric equipment




d925ae9b