7.3.4.1. Adjustment of passing beam

Fig. 7.22. Scheme of adjustment of passing beam of headlights

Install the screen for adjustment of light of headlights, as shown in the figure 7.22.

Bring air pressure in tires to norm.

Install not loaded car on a horizontal surface.

Place one person on a driver's seat.

Install the car directly and perpendicular to a wall.

Establish headlights at distance of 3 m from a wall (fig. 7.23).

Fig. 7.23. Scheme of installation of the car

At adjustment of one headlight, close another.

Start the engine for recharge of the rechargeable battery.

Turn on passing beam.

Install the switch of the proofreader of headlights in situation 0.

Fig. 7.24. Adjustment by rotation of adjusting screws

Adjust headlights rotation of adjusting screws, as shown in the figure 7.24. At first weaken screws, then tighten them.

NOTE If at first to tighten, and then to weaken adjusting screws, then they will turn away at the movement of the car that will lead to violation of adjustment of headlights.

Fig. 7.25. Scheme of the correct installation of a light bunch

Rotating adjusting screws, adjust a headlight so that the point of intersection of horizontal and inclined sites of light spots was in the place shown in the shaded area of the figure 7.25.