|
5-3-5-1-sborka-komponentov-nasosa-gidrousilitelya.html 5.3.5.1. Assembly of components of the pump of the hydraulic booster
Put on a clip in the direction shown in the figure 5.34.
Make sure that the ear of a clip is recorded.
Establish an epiploon in a forward pump housing, using special adaptation and the kapron hammer (fig. 5.35).
Place blades in a rotor so that the rounded edges were included into a cam (fig. 5.36).
Establish a statorny ring in a forward pump housing by a tag (fig. 5.37) up.
After installation of the back case manually turn a shaft to check smoothness of rotation.
Establish a shaft in a forward pump housing.
Install the pump and tighten three bolts of fastening.
Install pressure sensor socket.
Establish a driving belt.
Pump over a hydraulic contour of the steering mechanism.
Check whether there is no leak and dribble of working liquid of hydraulic system.
Make check and installation of a steering wheel.
|
|