Adjustment of a convergence of wheels. Mazda 3 (since 2003 release)
Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
4.1. Wheels and tires
4.1.1. Adjustment of angles of installation of wheels
4.1.2. Adjustment of an angle of rotation of forward wheels
4.1.2.1. Adjustment of a convergence of wheels
4.1.3. Adjustment of installation of back wheels
4.1.4. Balancing of wheels (16-inch and 17-inch cast light-alloy wheels)
4.2. Suspension bracket
4.3. Tables
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








4-1-2-1-regulirovka-skhozhdeniya-koles.html

4.1.2.1. Adjustment of a convergence of wheels

Weaken a lock-nut of a tip of steering draft.
Remove a lath cover collar.
Adjust a convergence of wheels rotation of both steering drafts (left and right) in opposite directions at an identical size.

NOTE
For one turn of steering draft of one wheel the corner of a convergence changes approximately on 6 mm.
Each steering draft has the right carving.

For increase in a corner of a convergence, rotate the right steering thirst for a forward part of the car, and the left steering thirst for a back part of the car at an identical size.
Tighten a lock-nut of a tip of steering draft.
Inhaling moment: 68,6–98,0 N · m.
Make sure that the cover of a lath is not overwound and establish a lath cover collar.

"previous page
4.1.2. Adjustment of an angle of rotation of forward wheels
following page"
4.1.3. Adjustment of installation of back wheels




d925ae9b