3.3.4.9. Installation of a cable of blocking

Make sure that the lever of the selector is in situation P and the ignition key is in position of LOCK.

Press the mechanism of blocking and rest it against a brake pedal limiter arm.

Fig. 3.94. Fixing of a hook of the mechanism of blocking in an arm opening

From this situation move the blocking mechanism reliably to record a blocking mechanism hook in an arm opening, as shown in the drawing the figure 3.94.

ATTENTION The excess or twisting of a cable of blocking at installation can negatively influence operation of the mechanism of blocking.

Fig. 3.95. Installation of a tip of a cable of blocking on a cam pin

Establish a blocking cable tip on a cam pin on the lever of the selector (fig. 3.95).

Fig. 3.96. Laying of a cable of blocking in a groove of the support plate of the lever of the selector

Lay a blocking cable in an U-shaped groove of the support plate of the lever of the selector and establish a clip (fig. 3.96).

ATTENTION Application of effort to a blocking cable at installation of a clamp can negatively influence operation of the mechanism of blocking.

Press a blocking cable clamp before you block it.

Fig. 3.97. Removal of a pin of the mechanism of blocking

Remove a blocking mechanism pin, as shown in the figure 3.97.

Turn the ignition key in the provision of ASSORTMENT.

Install a blocking cable on the key cylinder.

Fig. 3.98. Installation of a clip on a convex part of the external case of the cylinder

Move the external case to the cylinder of a key and establish a clip on a convex part of the external case (fig. 3.98).