Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.7.1. Check of pressure of oil
2.7.2. Replacement of engine oil
2.7.3. Installation of an oil filter
2.7.4. Removal and installation of the oil pallet
2.7.5. Removal and installation of the oil pump
2.7.6. Dismantling, check and assembly of the oil pump
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

2-7-1-proverka-davleniya-masla.html

2.7.1. Check of pressure of oil

ATTENTION
The hot engine and oil can become the reason of serious burns. Before check stop the engine and wait, so far the engine and engine oil will not cool down.

Remove the lower protective cover of the engine.
Remove the oil pressure sensor.

Fig. 2.286. Installation of special device for measurement of pressure of oil


Screw special adaptation in an opening of the sensor of pressure of oil (fig. 2.286).
Warm up the engine up to the normal working temperature.
Establish the specified turns of the engine and write down instrument readings.
If pressure differs from specified, find out the reason, and repair or replace if necessary the damaged details.

NOTE
Pressure of oil depends on viscosity and temperature.

Oil pressure at a temperature of 100 °C: 330–380 kPa.
Stop the engine and let's it cool down.
Remove special adaptation.

ATTENTION
Hit of sealing material on a working part of the sensor of pressure of oil can lead to a sensor conclusion out of operation. Make sure that on a working part of the sensor of pressure of oil there is no sealing material.


Fig. 2.287. The place of putting sealant on an oil pressure sensor carving


Apply kremniyevoorganichesky sealant on an oil pressure sensor carving, as shown in the figure 2.287.
Install the oil pressure sensor.
Inhaling moment: 12–18 N · m.
Establish a protective cover of the engine.
Start the engine and check lack of leak of oil. In the presence of leak, define a defective part, repair or replace it.

"previous page
2.7. Lubrication system
following page"
2.7.2. Replacement of engine oil