Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.6.1. Check of a belt of the drive of auxiliary units
2.6.2. Check of thermal gaps in the mechanism of the drive of valves
2.6.3. Check of a compression
2.6.4. Removal and installation of a chain of the drive of the mechanism of gas distribution
2.6.5. Replacement of laying of the block of cylinders
2.6.6. Replacement of a forward epiploon of a bent shaft
2.6.7. Replacement of a back epiploon of a bent shaft
2.6.7.1. Removal
2.6.7.2. Installation
2.6.8. Removal and installation of the engine
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 








2-6-7-1-snyatie.html

2.6.7.1. Removal

Remove from model with the automatic transmission:
– transmission;
– drive plate.
Remove from model with the mechanical transmission:
– working cylinder of coupling;
– the mechanical transmission in the block with the main transfer;
– flywheel.
Cut off a knife the worker an epiploon edge.

Fig. 2.279. Removal of a back epiploon


Remove an epiploon, using the screw-driver with the flat shliyets who is wrapped up by rags to prevent damage of an epiploon of a bent shaft (fig. 2.279).

"previous page
2.6.7. Replacement of a back epiploon of a bent shaft
following page"
2.6.7.2. Installation