Mazda 3 since 2003
1. Operation and maintenance of the car
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.6. The Z6 engine – a mechanical part
2.7. Lubrication system
2.8. Cooling system
2.9. System of an admission
2.10. Fuel system
2.11. System of production of the fulfilled gases and system of decrease in toxicity
2.11.1. Removal and installation of system of release
2.11.1.1. Removal
2.11.1.2. Installation
2.11.2. System of decrease in toxicity
2.12. System of ignition
2.13. Control system
2.14. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 










d925ae9b

2-11-1-1-snyatie.html

2.11.1.1. Removal

Uncover the rechargeable battery.
Disconnect a negative wire from the rechargeable battery.
Remove the lower cover.

Fig. 2.331. Components of system of production of the fulfilled car gases with the Z6 engine: 1 – cross-piece of the back tunnel; 2 – cross-piece of the forward tunnel; 3 – main muffler; 4 – the back sensor of concentration of oxygen with heating; 5 – the forward sensor of concentration of oxygen with heating; 6 – a pipe of recirculation of the fulfilled gases (from a final collector); 7 – element; 8 – arm of a final collector; 9 – clip; 10 – three-component catalytic converter; 11 – thermal screen of a final collector; 12 – laying of a final collector


Remove components in the order shown in the figure 2.331 on page 157.
Removal of a final collector / thermal screen of a final collector

ATTENTION
The excessive bend of an exhaust pipe can lead to its damage.

NOTE
At removal of a final collector, take aside the thermal screen of a final collector a little, weaken nuts, and then remove a final collector together with the screen. Address the following procedure.

Remove forward wheels.
Uncover the air filter and the case of the air filter.
Remove a pipe of recirculation of the fulfilled gases (from an inlet collector).
Remove knot of the valve of recirculation of the fulfilled gases.
Disconnect a steering shaft from the steering mechanism, disconnect steering drafts.
Disconnect a pressure head hose and a returnable hose.
Remove an engine No. 1 support.
Weaken bolts of the thermal screen of a final collector.
Take the thermal screen of a final collector a little aside and weaken nuts of a final collector.
Remove bolts of fastening of a forward cross-piece and the forward stabilizer of a suspension bracket.
Weaken bolts of fastening of a forward cross-piece and lower a forward cross-piece approximately by 100 mm.

Fig. 2.332. Fixing of a flexible pipe


Tie up a flexible pipe or record, as shown in the figure 2.332.
Remove a final collector together with the insulator having lowered it to the lower part of the car.

"previous page
2.11.1. Removal and installation of system of release
following page"
2.11.1.2. Installation