Mazda 3 since 2003
	1. Operation and maintenance of the car
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
		2.6. The Z6 engine – a mechanical part
		2.7. Lubrication system
		2.8. Cooling system
		2.9. System of an admission
		2.10. Fuel system
			2.10.1. Removal and installation of the block of the fuel pump
				2.10.1.1. Removal
				2.10.1.2. Installation
				2.10.1.3. Check of leak of fuel after installation of the block of the pump
			2.10.2. Removal and installation of a fuel nozzle
		2.11. System of production of the fulfilled gases and system of decrease in toxicity
		2.12. System of ignition
		2.13. Control system
		2.14. Tables
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-10-1-2-ustanovka.html

2.10.1.2. Installation

NOTE

If on laying there is a gasoline, the block of the fuel pump will be turned and it cannot be enshrined in the specified provision.

Carefully wipe all gasoline from laying.

Fig. 2.323. Combination of adjusting tags on the fuel pump and the fuel tank

Combine adjusting tags on the fuel pump and the fuel tank, as shown in the figure 2.323.

Install special adaptation.

Using special adaptation, tighten a cover of the fuel pump within the specified inhaling moment, without allowing the shift of adjusting tags.

If the specified moment of an inhaling does not manage to achieve, replace a cover of the fuel pump and laying.

If the specified moment of an inhaling does not manage to achieve after replacement of a cover of the fuel pump and laying, replace the fuel tank.

Moment of an inhaling of a cover of the fuel pump: 80–90 N · m.